This is the documentation for CDH 4.7.1. Documentation for other versions is available at Cloudera Documentation.

Cloudera Manager 4 and CDH 4 have reached End of Maintenance (EOM) on August 9, 2015. Cloudera will not support or provide patches for any of the Cloudera Manager 4 or CDH 4 releases after that date.

The HDFS Balancer

The HDFS balancer re-balances data across the DataNodes, moving blocks from over-utilized to under-utilized nodes. As the system administrator, you can run the balancer from the command-line as necessary -- for example, after adding new DataNodes to the cluster.

Points to note:
  • The balancer requires the capabilities of an HDFS superuser (for example, the hdfs user) to run.
  • The balancer does not balance between individual volumes on a single DataNode.
  • You can run the balancer without parameters, as follows:
    sudo -u hdfs hdfs balancer

    If Kerberos is enabled, do not use commands in the form sudo -u <user> hadoop <command>; they will fail with a security error. Instead, use the following commands: $ kinit <user> (if you are using a password) or $ kinit -kt <keytab> <principal> (if you are using a keytab) and then, for each command executed by this user, $ <command>

    This runs the balancer with a default threshold of 10%, meaning that the script will ensure that disk usage on each DataNode differs from the overall usage in the cluster by no more than 10%. For example, if overall usage across all the DataNodes in the cluster is 40% of the cluster's total disk-storage capacity, the script ensures that each DataNode's disk usage is between 30% and 50% of that DataNode's disk-storage capacity.
  • You can run the script with a different threshold; for example:
    sudo -u hdfs hdfs balancer -threshold 5
    This specifies that each DataNode's disk usage must be (or will be adjusted to be) within 5% of the cluster's overall usage.
  • You can adjust the network bandwidth used by the balancer, by running the dfsadmin -setBalanacerBandwidth command before you run the balancer; for example:
    dfsadmin -setBalanacerBandwidth newbandwidth
    where newbandwidth is the maximum amount of network bandwidth, in bytes per second, that each DataNode can use during the balancing operation. For more information about the bandwidth command, see this page.
  • The balancer can take a long time to run, especially if you are running it for the first time, or do not run it regularly.

For more information, see the Balancer Administrator Guide.

This page last updated August 5, 2015