This is the documentation for CDH 5.0.x. Documentation for other versions is available at Cloudera Documentation.

Configuring Oozie Failover (hot/cold)

  Note:

The functionality described below is supported in CDH 5, but Cloudera recommends that you use the new capabilities introduced in CDH 5 instead.

  1. Set up your database for High Availability (see the database documentation for details).
      Note:

    Oozie database configuration properties may need special configuration (see the JDBC driver documentation for details).

  2. Configure Oozie on two or more servers:
  3. These servers should be configured identically
  4. Set the OOZIE_HTTP_HOSTNAME variable in oozie-env.sh to the Load Balancer or Virtual IP address (see step 3)
  5. Only one of the Oozie servers should be started (the hot server).
  6. Use either a Virtual IP Address or Load Balancer to direct traffic to the hot server.
  7. Access Oozie via the Virtual IP or Load Balancer address.

Points to note

  • The Virtual IP Address or Load Balancer can be used to periodically check the health of the hot server.
  • If something is wrong, you can shut down the hot server, start the cold server, and redirect the Virtual IP Address or Load Balancer to the new hot server.
  • This can all be automated with a script, but a false positive indicating the hot server is down will cause problems, so test your script carefully.
  • There will be no data loss.
  • Any running workflows will continue from where they left off.
  • It takes only about 15 seconds to start the Oozie server.

See also Configuring Oozie to Use HDFS HA.

Page generated September 3, 2015.